Used to break loose supply connections and valve bodies without rounding the nuts, especially on older fixtures where corrosion has tightened everything up.
Faucet Repair southlake TX that stops the drip for good
Faucet Repair southlake TX means finding the actual failure, not just tightening a packing nut and hoping. We handle kitchen faucet repair southlake TX and bathroom faucet repair southlake for homeowners across Tarrant County, from Southlake Town Square to Timarron.
Serving southlake and nearby areas.
How big is the faucet job?
Full rebuild
New cartridge, seals, supply lines, and shutoff valves in one cabinet.
- 1. Cartridge swap One faucet, worn cartridge and seals, handle still turns freely.
- 2. Full rebuild New cartridge, seals, supply lines, and shutoff valves in one cabinet.
- 3. Fixture replacement Corroded valve body or cracked housing, so the faucet comes out.
Drag the needle to compareTouch and drag the needle
- 30Services from one local team
- 20Areas served around southlake
- Diagnose firstWe find the cause before quoting parts
- Test afterHot and cold checked before we pack up
What Our Faucet Repair Service Includes
Every faucet repair southlake TX call covers diagnosis, the repair itself, and a full test before we leave.
Work order
Faucet Repair- Full fixture diagnosis: We shut off the angle stops, pull the handle, and inspect the cartridge, seats, O-rings, and supply connections. You get a straight answer on whether the faucet is repairable or past saving, plus the price before we start.
- Cartridge and seal replacement: The core of most repairs. We install the correct Moen, Delta, Kohler, or American Standard cartridge and replace every worn O-ring and gasket, then cycle the handle to confirm smooth travel and no drip.
- Supply line and stop valve check: We inspect the supply lines and angle stops under the sink while we are in there. A seized or weeping shutoff valve is a flood waiting to happen, so we flag it and replace it if you want it done.
- Aerator cleaning and flow test: Mineral buildup chokes the aerator and drops your pressure. We clean or replace it, then run hot and cold on both sides to confirm full flow and correct temperature at the spout.
- Leak test and cleanup: Before we pack up, we watch the base, the spout, and every supply connection for any weep. Then we wipe down the sink and cabinet floor so you are not left with a mess to clean.
What the first visit covers
First visit
The first call or visit covers what happened, what the job involves and what happens next.
Faucet repair at Southlake homes
Kitchen, bath, wet bar, and laundry fixtures in houses across the city.
Kitchen sink drips
Cartridge and seal replacement on pull-down and standard faucets.
Bathroom faucet leaks
Base leaks, O-rings, and packing nuts on single and double handle.
Wet bar fixtures
Small fixtures that drip and scale up from hard water.
Laundry and utility sinks
Heavy-use faucets that wear out faster than kitchen fixtures.
Faucet repair for Southlake businesses
Restaurants, offices, and multi-unit properties with fixtures in constant use.
Restaurant kitchens
Pre-rinse and hand sinks that run all day.
Office restrooms
Metering and standard faucets in high-traffic bathrooms.
Rental properties
Unit turnover repairs documented for the property file.
Faucet Repair southlake TX done right the first time
A faucet that drips is not just noise. It wastes water every hour and slowly damages the cabinet under it. Fixing it properly the first time costs less than living with it.
Faucet repair southlake TX is the diagnosis and correction of a faucet that drips, leaks at the base, sprays sideways, or runs weak on one side. The work covers cartridge and seat replacement, O-ring and gasket swaps, valve seat resurfacing, supply line and shutoff valve replacement, and aerator cleaning. Most faucets fail at the cartridge, the seals, or the inlet connections, and each failure looks different at the spout. We identify which one you have before we touch a wrench.
Homes around Carillon and Clariden Ranch run hard water through their fixtures all year, and that mineral load eats rubber seals faster than most people expect. A faucet that drips a steady stream can waste hundreds of gallons a month and quietly raise your water bill. If you have been searching faucet repair near me southlake TX and putting it off, the leak is not going to seal itself. We fix it in one visit in most cases.
- What it is
- Diagnosis and repair of a dripping or leaking faucet.
- When it helps
- Drips, base leaks, weak flow, or a handle that will not close.
- What you get
- A tested fixture with no drip and full hot and cold flow.
How our faucet repair service works
You get a clear sequence from the first phone call to the final test.
Tools and Methods We Use
Each method answers a different question. Together they leave very little to guess.
Confirms whether a drip is coming from the faucet itself or from a hidden supply line or fitting behind the cabinet wall.
Lets us look inside drain lines when a faucet backup points to a deeper blockage rather than a fixture problem.
Cuts copper or PEX cleanly when a corroded section of supply pipe behind the faucet has to be removed and replaced.
Used to sweat copper fittings when we repair or replace supply piping that feeds the faucet.
When to Call for Faucet Repair in Southlake
A kitchen faucet in a Southlake Town Square home has dripped since spring and the handle feels gritty when you turn it.
We pull the cartridge, replace it along with the O-rings, clean the aerator, and inspect the supply lines and angle stops under…
HomesBoth bathroom faucets in a Timarron house are leaking at the base and the cabinet floor stays damp.
We replace the O-rings and packing nuts on both fixtures, swap out the old supply lines, and check the shutoff valves, which…
HomesA rental property in Carillon has a Moen faucet leaking at the base and the tenant is complaining about water in the cabinet.
We diagnose the cartridge and seals, replace the failed parts, and document what we found and what we replaced so the owner…
BusinessesA homeowner in Stone Lakes wants to know whether to repair an older Kohler faucet or replace it.
We inspect the cartridge, valve body, and finish. If the body is sound, we quote a repair.
Homes
How Faucet Repair Works in Southlake
Southlake sits in Tarrant County, and the water here runs hard. That mineral load is the single biggest reason faucet cartridges and O-rings fail faster in this city than in softer-water areas.
Southlake Town Square
A mix of newer condos and older homes, so we see both modern cartridge faucets and original fixtures that need full rebuilds.
Timarron
Many homes here are 20-plus years old with original kitchen and bath faucets, and the cartridges are at the end of their life.
Carillon
Newer construction with builder-grade fixtures that tend to fail at the seals first, usually within the first decade.
- Southlake Town Square
- Timarron
- Carillon
- Stone Lakes
- Clariden Ranch
From problem to finished result.
Slide to compare the photo with an illustrative inspection view. It is generated from the photo, not a measurement.
PhotoKitchen faucet drip stopped in Timarron
Before: A Moen kitchen faucet had dripped at the spout for months. The homeowner estimated it had been running since spring, and the basin had a visible mineral ring. The handle felt gritty and needed extra force to close.
After: We replaced the cartridge and O-rings, cleaned the aerator, and tested hot and cold. The drip stopped completely, the handle moved smoothly, and flow returned to full pressure on both sides. The job took about 50 minutes.
Bathroom faucets resealed in Southlake Town Square
Before: Both bathroom faucets leaked at the base, and the cabinet floor stayed damp. The supply lines were original, and the angle stops had not been turned in years. One stop was seized open.
After: We replaced the O-rings and packing nuts on both fixtures, installed new supply lines, and swapped the seized angle stops. The cabinet dried out, both faucets sealed, and the shutoffs now work so the sinks can be isolated individually.
Corroded Kohler replaced in Stone Lakes
Before: A homeowner asked us to repair an older Kohler faucet that had started leaking at the base. On inspection, the valve body was corroded through and the finish was pitted. A cartridge swap would not have sealed it.
After: We quoted a replacement, and the homeowner chose a new Kohler fixture. We installed it, set new supply lines, and tested hot and cold.
Faucet Problems We Fix in Southlake Homes
Most faucet calls fall into a handful of failure patterns.
Faucet drips constantly at the spout
A steady drip wastes thousands of gallons a year, raises your water bill, and leaves mineral stains in the basin that etch the finish over time.
Water pooling at the base of the faucet
Water seeps under the fixture, swells cabinet wood, and stains stone counters. Left alone, it can rot the cabinet floor and reach the shutoff valves.
Weak or uneven flow on one side
Low pressure on hot or cold points to a clogged aerator, a failing cartridge, or scale in the supply line.
Faucet will not shut off completely
We shut off the angle stops first, then rebuild the valve with a new cartridge and seats.
Why homeowners call us for faucet fixing southlake
A dripping faucet is a small problem that turns into a big one.
Stop the water waste
A faucet dripping once per second wastes roughly 3,000 gallons a year.
Protect the finish and counter
Water that pools at the base of a faucet etches stone counters, swells cabinet wood, and leaves mineral rings that never come out.
One visit, most repairs
Our trucks carry Moen, Delta, Kohler, and American Standard cartridges, plus brass fittings, supply lines, and Teflon tape.
Fix the cause, not the symptom
Tightening a packing nut stops a drip for a week. Replacing the worn cartridge and inspecting the shutoff valve underneath stops it for years.
What we leave behind
Clear records you can keep and share.
Written findings
What failed and what we replaced, in plain terms.
Part details
Brand and part number of the cartridge or fixture used.
Test record
Hot and cold flow and leak check noted before we leave.
16 years of faucet repair experience in Southlake
Southlake Oakline Plumbing has been fixing fixtures in this area since 2010, which means 16 years of cartridges, corroded valve bodies, and hard-water damage on the…
Cartridge wear
We read the seal and seat surface to tell whether a swap will hold or the body is done.
Shutoff condition
We turn each angle stop to confirm it closes, because a seized stop turns a repair into a flood.
Supply line age
We check the line material and fittings for corrosion that would fail soon after the repair.
Is your Southlake neighborhood covered?
Type your ZIP code or town to check. If you are nearby and not listed, call and ask.
southlake ZIP codes
- 76092
Towns we serve.
Based in southlake and covering the places around it. Pick one for local details.
What Southlake Customers Say
Our kitchen faucet had been dripping for months and I kept putting it off. They pulled the cartridge, showed me the worn seal, and had a Moen replacement on the truck. Whole thing took about 50 minutes. The drip is gone and the handle moves smoother than it did when the house was new.
Both bathroom faucets were leaking at the base and the cabinets were getting damp. They replaced the O-rings and the supply lines, then checked the angle stops, which were seized. Fixed all of it in one visit. No more water in the cabinet and the price matched the quote exactly.
We manage several units and had a run of dripping faucets across two buildings. They handled the cartridge swaps and replaced a couple of fixtures that were too corroded to save. Clear pricing, no upsell, and they tested hot and cold at every sink before signing off. We use them for all our fixture work now.
Frequently Asked Questions
Short answers for the first few minutes. The team can cover the rest.
Still have a question?
Describe what you are seeing and we will point you to the right next step.
(682) 470-5111A simple cartridge swap on a Moen or Delta kitchen faucet sits at the low end. A full rebuild with new supply lines and angle stops, or a bathroom faucet with a corroded valve body, lands higher. If the fixture is past saving, we quote a replacement before doing anything.
In Southlake, the usual cause is hard water eating the rubber seals and cartridge O-rings. That shows up as a drip at the spout. A leak at the base is usually a failed O-ring or a loose packing nut. Water spraying sideways points to a cracked cartridge. We pull the handle and identify which one you have in about 15 minutes.
You can swap a cartridge if you shut off the angle stops first and match the part number exactly. What trips most homeowners up is a seized shutoff valve that will not close, or a corroded valve seat that a new cartridge will not seal against. If the stops will not turn, call us before you force them and flood the cabinet.
A standard cartridge replacement takes 45 minutes to an hour. A full rebuild with new supply lines and shutoff valves runs about two hours. We schedule a window, show up inside it, and test hot and cold before we leave. Most leaky faucet repair southlake Texas calls are done in a single visit.
Related Services
Other services from the same team.
- Faucet InstallationNew faucet installation includes removing the old fixture, cleaning the mounting surface, and connecting the supply lines.
- Toilet RepairA running toilet can waste hundreds of gallons a day.
- Toilet InstallationToilet installation takes about two hours, including pulling the old unit, setting the new wax ring, and connecting…
Book faucet repair southlake TX before the drip gets worse
(682) 470-5111One dripping faucet can waste thousands of gallons a year and quietly damage your cabinets. We stock the cartridges, seals, and supply lines to fix most fixtures in a single visit.
contact Southlake Oakline Plumbing
Call us at (682) 470-5111 for same-day service or to schedule an appointment. You can also email info@southlakeoaklineplumbing.com or stop by our office in Southlake.