Reaches the mounting nuts behind the sink basin where a standard wrench won't fit. Essential for removing and installing faucets without scratching the sink or countertop.
Faucet Installation southlake TX Done Right the First Time
When you need faucet installation southlake TX homeowners can count on, our team handles everything from a single bathroom faucet swap to a full kitchen faucet installation southlake project.
Serving southlake and nearby areas.
How big is the faucet job?
Faucet plus valves
New faucet with shutoff valve or supply line replacement.
- 1. Single swap One faucet replaced, existing valves and lines in good shape.
- 2. Faucet plus valves New faucet with shutoff valve or supply line replacement.
- 3. Full under-sink Faucet, valves, lines, and drain assembly replaced together.
Drag the needle to compareTouch and drag the needle
- 30Services from one local team
- 20Areas served around southlake
- Inspect firstWe check valves and lines before we start
- Pressure testEvery connection tested at full pressure
What Our Faucet Installation Includes
Every faucet installation southlake TX job includes the full scope below.
Work order
Faucet Installation- Old Faucet Removal: We disconnect the supply lines, loosen the mounting nuts with a basin wrench, and lift the old fixture out. Mineral buildup and rust can make this stubborn, but we've pulled hundreds of fixtures and know how to free them without damaging your sink or countertop.
- New Faucet Installation: We set the new fixture with fresh gaskets, apply Teflon tape and pipe thread sealant to every threaded connection, and hand-tighten plus a quarter-turn. Supply lines get routed cleanly, and sprayer hoses are checked for kinks before we button everything up.
- Supply Line Inspection: We check every supply line for brittleness, corrosion, and kinks. If a line is more than 10 years old or shows signs of cracking, we recommend replacement.
- Shutoff Valve Check: Angle stops seize up over time, especially in hard water areas. We test both hot and cold valves. If they won't close fully or are corroded, we replace them while we're already under the sink. It's cheaper to do it now than during an emergency.
- Full Pressure Test: We turn the water back on, run hot and cold at full pressure, and check every connection for drips. Then we run the faucet through its full range, including any pull-down or sensor features.
- Cleanup and Haul-Away: We lay drop cloths before we start and clean up when we're done. The old faucet goes with us. You won't find water spots on your cabinets or grease on your backsplash. Your kitchen or bathroom looks the same when we leave, just with a better faucet.
What the first visit covers
First visit
We inspect the shutoff valves, supply lines, and drain assembly, then quote the full job before any work begins.
Faucet Installation for Southlake Homes
We install and replace faucets in kitchens, bathrooms, and utility sinks across Southlake.
Kitchen faucets
Pull-down, touchless, and high-arc fixtures installed.
Bathroom faucets
Single and two-handle fixtures for vanities and powder rooms.
Utility sinks
Heavy-duty faucets for laundry and garage sinks.
Bar and prep sinks
Compact faucets for wet bars and prep areas.
Faucet Installation for Southlake Businesses
We handle faucet installation and replacement for commercial properties across Tarrant County.
Restaurant kitchens
Pre-rinse sprayers and heavy-duty faucets.
Office restrooms
Commercial-grade faucets and sensor fixtures.
Retail and hospitality
Public restroom and breakroom faucet replacement.
Faucet Installation southlake TX: What the Job Actually Involves
A faucet installed correctly lasts 15 years or more. A faucet installed with cross-threaded fittings and reused gaskets leaks within months. We do it right the first time.
We shut off the water, disconnect the old faucet, inspect the valve seats and supply lines for corrosion, then set the new fixture with fresh Teflon tape and pipe thread sealant on every threaded connection. A pipe wrench and basin wrench handle the tight spots under the sink. We test for leaks at full pressure before we pack up.
Southlake homes deal with hard water that eats through rubber washers and mineral-crusts aerators faster than most homeowners expect. If your faucet drips at 2 a.m. or your kitchen sprayer has lost pressure, that's usually mineral buildup, not a failed cartridge. We see this constantly in neighborhoods like Timarron and Carillon, where original builder-grade fixtures are now 15 to 20 years old. A new faucet install southlake TX residents schedule with us solves the drip and upgrades the look in one visit.
- What it is
- Removal of the old faucet and installation of a new one.
- When it helps
- Drips, low pressure, corrosion, or a remodel.
- What you get
- A leak-free faucet tested at full pressure.
Our Faucet Installation Process
Every faucet replacement southlake job follows the same five steps. No surprises, no mystery charges, no waiting around all day for a technician who never shows.
Tools and Methods We Use
Each method answers a different question. Together they leave very little to guess.
Provides the leverage needed to loosen corroded supply line fittings and shutoff valves. We use padded jaws to avoid marring chrome or brass finishes.
Applied to every threaded connection to prevent leaks. Teflon tape handles most fittings; pipe thread sealant is used on larger threads and gas lines.
Replaces brittle or corroded lines during every faucet install. Braided stainless resists bursting and lasts longer than plastic or rubber lines.
Used to trace hidden leaks when a faucet drips only intermittently or when water appears under the cabinet with no visible source.
When Southlake Homeowners Call Us for Faucet Work
Kitchen remodel in a 1990s Timarron home with original builder-grade fixtures
We remove the old faucet and disposal, install a new pull-down Moen or Delta fixture, replace the shutoff valves and supply lines,…
HomesBathroom faucet replacement in a Carillon home with hard water damage
We remove the corroded fixture, inspect the valve seats, and install a new WaterSense-labeled faucet.
HomesEmergency faucet replacement after a supply line burst under the sink
We shut off the main water supply, assess the damage, and replace the failed supply line and faucet.
HomesUpgrading to a touchless kitchen faucet in a Southlake Town Square condo
We install the new touchless fixture, route the sensor wire, and connect the AC adapter or battery pack.
Homes
How Faucet Installation Works in Southlake
The mineral content coats cartridges, clogs aerators, and corrodes valve seats faster than in softer-water areas. Homes in Timarron and Carillon built in the late 1990s and early 2000s are now hitting the 20-year mark, and original builder-grade fixtures are failing across those neighborhoods.
Timarron
Many homes here were built in the late 1990s with builder-grade Moen and Delta fixtures that are now failing. We stock the right cartridges and supply lines for these models.
Carillon
Hard water damage is common in this neighborhood. We often replace shutoff valves along with the faucet because the originals are seized or corroded.
Southlake Town Square
Condos and townhomes here often have tight under-sink spaces. We use compact basin wrenches and flexible supply lines to work in confined areas without damaging cabinets.
- Timarron
- Carillon
- Southlake Town Square
- Clariden Ranch
From problem to finished result.
Slide to compare the photo with an illustrative inspection view. It is generated from the photo, not a measurement.
PhotoKitchen Faucet Upgrade in Timarron
Before: A 2001 builder-grade Moen faucet with a dripping cartridge and a sprayer that had lost all pressure. The shutoff valves were original and seized. The homeowner had been living with the drip for eight months.
After: We installed a new pull-down Delta faucet with a high-arc spout, replaced both shutoff valves with quarter-turn ball valves, and swapped the supply lines for braided stainless. The drip stopped, pressure returned, and the kitchen looked updated.
Bathroom Faucet Replacement in Carillon
Before: Both bathroom faucets were original to the 2003 house and had severe mineral buildup. The handles were stiff, and one faucet dripped constantly. The homeowner was embarrassed to have guests use the bathroom.
After: We replaced both faucets with WaterSense-labeled Kohler fixtures, cleaned the supply lines, and replaced the corroded shutoff valves. The handles now move smoothly, and the drip is gone. Water usage dropped by about 20%.
Emergency Supply Line Replacement in Southlake Town Square
Before: A braided supply line burst under the kitchen sink at 6 a.m., flooding the cabinet and spreading water across the hardwood floor. The homeowner shut off the main water supply and called us.
After: We replaced the failed supply line, installed a new Moen faucet, and dried the cabinet with fans. The hardwood floor was saved with minimal damage. The whole job took four hours from call to completion.
Faucet Problems We Solve for Southlake Homeowners
Most faucet issues start small and get expensive fast.
Constant drip that won't stop
A dripping faucet wastes 3,000 gallons a year and stains the sink basin.
Low water pressure at the faucet
Mineral buildup in the aerator or cartridge restricts flow. If left alone, the cartridge can seize and the handle will stop moving entirely.
Leaking under the sink
A leaking supply line or drain connection causes cabinet damage, mold growth, and warped flooring. Water damage repairs often cost more than the faucet itself.
Corroded shutoff valves
Seized angle stops won't close when you need them to. If a supply line bursts, you can't shut off the water without calling the city.
Why Southlake Homeowners Upgrade Their Faucets
A new faucet stops the drip, cuts water waste, and modernizes the busiest rooms in your house.
Stop Wasting Water
A dripping faucet wastes 3,000 gallons a year, according to EPA WaterSense estimates. That's real money on your Southlake water bill.
Fix It Before It Floods
Replacing the faucet is the right time to swap those lines and valves too.
Upgrade Without the Headache
Pull-down sprayers, touchless sensors, and high-arc designs look simple on the showroom floor.
Protect Your Countertop
A wrench slip on a quartz or granite countertop leaves a permanent scratch.
What you receive on a faucet job
Clear records you can keep and share.
Inspection findings
Notes on valve and supply line condition.
Written quote
Full job price before work begins.
Test results
Pressure test confirmation for every connection.
16 Years of Faucet Work in Southlake
Southlake Oakline Plumbing has been installing faucets since 2010. We've installed thousands of fixtures across Tarrant County, from basic builder-grade replacements to high-end touchless kitchen systems.
Valve condition
We check if shutoff valves close fully and turn freely.
Supply line age
We look for brittleness, corrosion, and kinks in the lines.
Drain assembly
We inspect the P-trap and basket strainer for corrosion.
Is your Southlake neighborhood covered?
Type your ZIP code or town to check. If you are nearby and not listed, call and ask.
southlake ZIP codes
- 76092
Towns we serve.
Based in southlake and covering the places around it. Pick one for local details.
What Southlake Homeowners Say
Our kitchen faucet had been dripping for months and the sprayer had zero pressure. Southlake Oakline came out on a Tuesday morning and had the new Moen installed by lunch. They also replaced both shutoff valves, which were original to the house. Clean work, fair price, and they hauled away the old fixture. I'll use them again.
I bought a touchless Kohler faucet and quickly realized I was in over my head. Called these guys and they had it installed in about three hours. They drilled the deck hole cleanly, routed the sensor wire, and tested everything. No leaks, no mess. Worth every penny.
Both bathroom faucets were original to our 2003 house and looked terrible. We scheduled a replacement for both, and the technician finished in under four hours. He showed us how to clean the aerators and recommended a water softener for the hard water issue. Honest advice, no upsell pressure.
Faucet Installation Questions Southlake Homeowners Ask
Short answers for the first few minutes. The team can cover the rest.
Still have a question?
Describe what you are seeing and we will point you to the right next step.
(682) 470-5111A basic bathroom faucet swap is on the low end. A kitchen faucet with a pull-down sprayer, new valves, and a garbage disposal disconnect runs higher. We quote the full job before we start.
You can, but most homeowners call us after they've stripped a mounting nut or cross-threaded a supply line. The tricky parts are reaching the mounting nuts with a basin wrench, matching supply line threads, and getting the drain gasket seated without leaks. If you're comfortable under a sink with basic tools, it's doable. If not, we'll handle it in two hours.
A standard faucet replacement takes two to four hours. Bathroom faucets are usually closer to two hours. Kitchen faucets with pull-down sprayers, soap dispensers, or garbage disposal connections take three to four. If we find corroded shutoff valves or damaged supply lines, add another 30 to 60 minutes for those replacements.
We're happy to quote the job either way.
Other Plumbing Services We Handle
Other services from the same team.
Ready for Faucet Installation southlake TX?
(682) 470-5111We quote the full job before we start, show up when we say we will, and clean up when we're done. Call Southlake Oakline Plumbing at (682) 470-5111 to schedule your faucet installation or replacement.
contact Southlake Oakline Plumbing
Call us at (682) 470-5111 for same-day service or to schedule an appointment. You can also email info@southlakeoaklineplumbing.com or stop by our office in Southlake.